Fiero Wheel Center Cap Refinishing Tool

Fiero Wheel Center Cap Refinishing Tool

Take your old discolored and tarnished center caps and refinish them to look like new again!

If you have old center caps that are in poor condition you can refinish them and make them look nice again. Tipically you would like to have a metal lath so you could chuck them up and spin then so you could sand them. Unfortunately few have the luxury of having a metal lath. This tool allows you to use a common hand drill clamped in a workbench vice to be the metal lath. Just push the center cap on the tool and run the drill. You have a nice variable speed spinning center cap to work on!
I include a step by step and tips sheet. Results will vary.

Fiero Wheel Center Cap Refinishing Tool

Fiero Wheel Center Cap Refinishing Tool
Fiero Wheel Center Cap Refinishing Tool Installed

If you have old center caps that are in poor condition you can refinish them and make them look nice again. Tipically you would like to have a metal lath so you could chuck them up and spin then so you could sand them. Unfortunately few have the luxury of having a metal lath. This tool allows you to use a common hand drill clamped in a workbench vice to be the metal lath. Just push the center cap on the tool and run the drill. You have a nice variable speed spinning center cap to work on!

Wheel Center Cap Refinishing Tool Setup

Fiero Wheel Center Cap Refinishing Tool
Code	Qty	Description	Item Cost
		Fiero Wheel Center Cap Refinishing Tool $2.50 S&H	$11.00

No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.

If you have old center caps that are in poor condition you can refinish them and make them look nice again. Tipically you would like to have a metal lath so you could chuck them up and spin then so you could sand them. Unfortunately few have the luxury of having a metal lath. This tool allows you to use a common hand drill clamped in a workbench vice to be the metal lath. Just push the center cap on the tool and run the drill. You have a nice variable speed spinning center cap to work on! I include a step by step and tips sheet. Results will vary.

Fiero Wheel Center Cap Refinishing Tool	Fiero Wheel Center Cap Refinishing Tool Installed
If you have old center caps that are in poor condition you can refinish them and make them look nice again. Tipically you would like to have a metal lath so you could chuck them up and spin then so you could sand them. Unfortunately few have the luxury of having a metal lath. This tool allows you to use a common hand drill clamped in a workbench vice to be the metal lath. Just push the center cap on the tool and run the drill. You have a nice variable speed spinning center cap to work on!