Shifter Rebuild Kits

 

This kit is to rebuild the shifter assembly that is in the center console. Includes oilite bushings to replace the original plastic bushings, a new select shaft and brass round piece that replaces the round ball and several shims. This will make your Getrag shifter assembly like new or even better than new.

These kits are easy to install but it will require you to remove the shifter assembly from the car. A bit of effort but worth it if you want to make your shifter like new.

.

 Shifter Rebuild Kit

Shifter Rebuild Kit

Kits now available for both the Getrag 5-spd and Isuzu 5-spd shifters.

(Please specify transmission type when ordering)

 

  • Restore Shifter Feel To Like New Condition !!
  • High Quality Oilite Bushings Better Than OEM !!
  • Easy To Install !!
 Shifter Rebuild Kit (Shown Installed On Assembly)
 

This is a Getrag shifter assembly. The main difference between the Isuzu and the
Getrag is the center pivot area. You will notice on this Getrag shifter
assembly that the cross bolt is encased in a tube. The Isuzu shifter has no tube
and you can see the pivot bolt.

The late 86-88 V-6 5 speed Fiero has a Getrag transmission.
The 85-88 4 cylinder 5 speed Fiero has a Isuzu transmission.

Note: Most 1988 4 cylinder Fieros with the Isuzu 5 speeds appear to have come from the factory with the Getrag type 5 speed shifter. Please verify which shifter assembly you have in your Fiero before ordering.

Please read before ordering:
In some cases a previous owner may have changed the shifter assembly in your Fiero. I have seen some where it appears they came from the factory with the incorrect shifter. You can not just assume that you have a Getrag shifter if you have a V-6 5 speed or an Isuzu shifter if you have a L4 and a 5 speed. In 99% of the cars I have sold these for the shifter matches the transmission. To be sure you are ordering the correct kit please take a minute and pull the console top off and look and compare it to the picture above. The Getrag shifter is in the picture above. The kits are different and will not interchange.

 

Shifter Rebuild Kits
CodeQtyDescriptionItem Cost
Shifter Rebuild Kits
$4.00 S&H Trans: 		$29.00

Firm up your shifting action even more with select lever rebuild kits:

For Getrag
For Isuzu

Back to previous page

 


Copyright © Rodney Dickman's Fiero Accessories. 2000-2009. All Rights Reserved
No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.