Clutch Pedal Conversion Pin

Clutch Pedal Conversion Pin

This pin is used to replace the large pin on the early clutch pedals to convert them to the late small pin design. This allows you to use my high quality brass oilite bushing instead of the steel on steel. It also allows you to convert the mid design all steel clutch pedals with the large pin into the small late design pin.
	Clutch Pedal Conversion Pin (shown with oilite bushing)

To install it you have to remove the clutch pedal. You then have to hack saw off the swegged over end of the original pin and pound it out. The new pin just bolts in.

Clutch Pedal Conversion Pin
Code	Qty	Description	Item Cost
		Clutch Pedal Conversion Pin w/ Oilite Bushing $3.00 S&H*	$17.00
		Clutch Pedal Conversion Pin $3.00 S&H*	$14.00

* Discount S&H charge. Order multiples of this item and save!!

No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.