Euro Shifter Replacement Arm

The original FiEuro Shifters (shown on the right) had some design flaws which are corrected with my Fiero Euro Shifter Replacement Arm.   If you own the FiEuro Shifter and are not satisfied with it, then the Fiero Euro Shifter Replacement Arm is for you!

FiEuro/Shift ad

 

Problem Original Euro
Shifter Arm		 Euro Shifter Replacement Arm Advantage
Shifter arm too tall   1-1/2" shorter Euro Shifter Replacement Arm
Tilt of shifter in neutral Tilts forward Stands Straight up Euro Shifter Replacement Arm
Shaft too large 16mm diameter shaft 10mm diameter shaft Euro Shifter Replacement Arm
Shift knob too big 2" diameter shifter knob 1-3/4" diameter shifter knob Euro Shifter Replacement Arm
Shifter did not look professional Dull shaft Highly polished stainless steel shaft Euro Shifter Replacement Arm
Shifter throw too long   Shorter throw due to shorter height and lower half of arm is longer* Euro Shifter Replacement Arm

This is a top quality replacement component! Fits all 1984 to 1988 Fieros - 4 and 5 speeds!

*Part of the reduced shift throw is obtained by the lower section of the shift arm being longer in length.


Fiero Euro Shifter Replacement Arm
consists of:
  • New shifter arm assembly with polished stainless steel
  • 1-3/4" Black shifter ball
  • Stainless steel locknut (optional use)
  • Installation instructions


Fiero Euro Shifter Replacement Arm

Important Note : I do not sell the gated plate. Just a better arm if you have this shifter kit.

Euro Shifter Replacement Arm
CodeQtyDescriptionItem Cost
Fiero Euro Shifter Replacement Arm
7.00 S&H
$61.00

Back to previous page

Copyright © Rodney Dickman's Fiero Accessories. 2000-2003. All Rights Reserved
No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.