3.4 V6 Swap Starter Relocation Jig Kit

This complete kit contains everything you will need to fabricate new starter holes on the adjacent side of the 3.4 V6 block. This drill jig also works with on other 60 degree V-6's such as the 3.1 and the 2.8. The jig provides both Correct Angle Drill Guides, and Tap Angle Guides, to assure your new starter holes will have perfect accuracy. Easy for the do it yourselfer to use. All that is needed is an electric hand drill. Included with each drill jig kit is a detailed step by step instruction sheet.

NOTE: Will also work for the Izuzu Trooper

3.4 Swap Starter Jig Kit

3.4 Swap Starter Relocation Jig Kit

3.4 V6 Swap AC Compressor Bracket

This bracket is used when you install a Camaro / Firebird 3.4 V6 in an 88 Fiero. It allows you to retain the Fiero 88 V6 AC compressor bracket. In the past you would have had to install a 85-87 cast iron bracket from a 2.8 V6, and then weld in a stud. You would also have had to replace the 88 AC compressor bracket with an 85-87 compressor bracket to make it all work together. This bracket allows you to retain all of the stock 88 air conditioner parts when installing a 3.4.

3.4 AC Conversion Bracket
3.4 V6 Swap AC Compressor Bracket


Oil Sender Tap Fitting Adapter

Fitting required for the oil sending unit on 3.4 block for A/C cars.

Oil Sender Fitting Adapter


 

3.4 V6 Swap Parts
CodeQtyDescriptionItem Cost
3.4 V6 Swap AC Bracket
$6.00 S&H 		$39.50
Oil Sender Fitting Adapter
$3.00 S&H* 		$3.00
Starter Relocation Jig Kit
$12.00 S&H 		$59.00

* Discount S&H charge. Order multiples of this item and save!!

Back to previous page

Copyright © Rodney Dickman's Fiero Accessories. 2000-2003. All Rights Reserved
No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.