T-10 TORX BIT

This is the hard to find size tamper-proof T-10 torx bit. To use this torx bit you will use a 1/4" socket in your 1/4" drive ratchet or a 1/4" nut driver type wrench. This special T-10 is needed to remove the factory V6 fuel pressure regulator screws.

T-10 TORX BIT

T-10 TORX BIT

 

T-10 TORX BIT
CodeQtyDescriptionItem Cost
T-10 TORX BIT
2.00 S&H 		$4.85

Back to previous page

 


Copyright © Rodney Dickman's Fiero Accessories. 2000-2003. All Rights Reserved
No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.