Shift and Select Cable Repair Kits

A common problem with older shift and select cables is that the cable is still in good condition but the plastic end pops off the ball stud. This is a simple repair kit to remedy that problem.
To install this repair kit you will need to drill out the end and go completely through the plastic end. A correct size drill bit is included. The new end is then installed as shown. Remove your old ball stud and reinstall this fixed and your plastic end will never come off again.

There are two sizes of ball studs used on the Pontiac Fiero. Small and large. The small is generally used on all but the V-6 4 speed shift cable. The V-6 4 speed shift cables generally have the large diameter ball stud. Please check and see what size ball stud you have before ordering. The small ball stud is about 10mm (3/8") while the large ball stud is about 12.5 mm - 13 mm (1/2"). Please see drawing below on how to measure the diameter of the ball stud on your transmission cable end.

Shift and Select Cable Repair Kits
Code	Qty	Description	Item Cost
		Shift and Select Cable Repair Kits $5.00 S&H Size: Small Large	$16.50