IAC Socket

This is a specially made 32 mm deep socket for removing the IAC from the 2.8 V-6 Fiero engine. Typically if you find a socket to fit the IAC it will be slightly too large and it will scrape the side of the aluminum housing when used. I had these sockets specially made thinner so when you put it on an IAC it does not hit the aluminum housing. 1/2" drive.

IAC Socket

 

IAC Socket
CodeQtyDescriptionItem Cost
IAC Socket
$6.00 S&H* 		$6.75

* Discount S&H charge. Order multiples of this item and save!!

Back to previous page

Copyright © Rodney Dickman's Fiero Accessories. 2000-2003. All Rights Reserved
No part of this site may be copied or stored in an archival system without prior written permission of Rodney Dickman's Fiero Accessories.. Rodney Dickman's Fiero Accessories is NOT associated with General Motors Corp. or any of it's subsidiaries. References to products on this site are made for identification purposes only.